If you are experiencing 2014 Honda Cr-V noise when starting, there are several possible reasons. These include: dirty battery terminals, a faulty timing mechanism, or rodents. To diagnose the problem, you need to check each of these items separately. If all of these have not fixed the problem, it may be time to contact a mechanic.
Starter solenoid
If your Honda CR-V is having trouble starting, you may have a problem with the starter solenoid. The starter solenoid receives an electrical current from the ignition system and closes a pair of electrical contacts. This allows the starter motor to turn and engage the flywheel. Once the flywheel engages, a series of components are set in motion to move the engine. If your starter solenoid is not working properly, you may need to replace it.
A weak battery is another possible reason for the CR-V not to start. You should check the battery terminals to ensure that they are clean. If they are dirty, check the connections for corrosion.
faulty timing mechanism
If you’ve been driving a 2014 Honda Cr V, you’ve probably noticed a rattle at the start of the car. That noise is most likely the result of a faulty timing mechanism. If you’re having trouble starting your car, you may need to replace the entire timing chain, tensioner, and guides. While the manufacturer of your vehicle is aware of the problem, there hasn’t been a recall or service bulletin for this problem.
While this issue isn’t a recall, you should have your engine checked by a mechanic to rule out any other problems with the car. While you’re at it, take the car to a dealership to have your car checked.
dirty battery terminals
If your car’s battery is showing signs of corrosion, it might be time to replace it. Corrosion is visible as a white or blue powdery substance that coats the battery terminals. This corrosion can prevent electricity from flowing through the battery to the electrical components. Although cleaning can repair limited corrosion, severe corrosion may require a new battery terminal. Corrosion develops over time, and it’s most common when a battery hasn’t been maintained properly.
To clean corroded battery posts, you can use a baking soda and water solution. Make sure to wear gloves and eye protection. You can also scrub the terminals with a wire brush.
rodents
If your 2014 Honda Cr V is making a noise when starting, rodents may be to blame. Rodents may be chewing on the wiring harness or chewing on the starter connector, which can damage these components. You can easily remedy this issue by cleaning the area with sandpaper and performing a continuity test. You should be able to get 12+ volts and 0 ohms at the starter terminal.
Another common problem that can cause the CR-V to make noises while starting is dirty battery terminals. To identify whether the terminals are dirty, look for corrosion on the plastic covers covering the battery. You should notice white or silvery green deposits on them.
blown main fuse
If you’re having trouble starting your 2014 Honda Cr-V, you may have a blown main fuse. Fuse boxes contain a small metal conductor that melts when exposed to higher currents than the fuse’s rating. Check the resistance of the fuse by examining its top part. It should read 0 Ohm, which indicates a good fuse.
Then, test the other fuses. If none of them are blown, then the problem is with the ignition switch. The switch makes a clacking noise if the voltage drops. It may also be a defective ignition lock or a faulty key. If this is the case, it’s not recommended to attempt to repair the problem yourself.
